Thursday, September 15, 2011

How hard is it to convert a 1954 Chevy truck from a manual to an automatic?

I'm thinking about getting a 1954 Chevy truck that's currently a manual and i'd like to convert it to an automatic can anyone give advise on the cost to do such a thing?|||It's a lot less costly then trying to change from an auto to a manual.


Depending on whether you already have the tranny or not, it's cost will have to be considered. If the truck is a SBC, them there are several transmissions that will interchange. The t350, t400, 200metric which has overdrive, and a 2 spd power-glide.


The clutch pedal assembly will need to be removed and all the linkage.


The transmission, clutch, pressure plate, shifter, pilot bearing, and flywheel will also need to be removed.


You will need the trans., torque converter, flywheel, different front drive-shaft yoke, and possibly the starter and cross-member will need to be replaced.


It is easier to add a floor shifter for your auto then to try and change out the steering column and run new linkage.


Price wise, your looking at around 500 for labor and at least 1000 for parts. Depending on where you are located the labor could double and depending on whether you want brand new parts or used parts, the price could reach 1500.


This is a time consuming job, but not an impossible one.


Hope this helps. Christopher|||It depends. If it has the original engine, trans, and rear axle. It's not hard, but you will end up replacing at least the trans, driveshaft, and rear axle. If someone has already converted it to a later model drivetrain, like a small block chevy and used a newer rear axle that does not have the torque tube driveshaft it will be a simple transmission swap.|||You didn't state whether the truck has the original Blue-Flame Six in it or it was converted to a small block Chevy. If it is original, the bolt pattern is different than the new engines, and an automatic would not be an option! Pick up an old hot rod trucks magazine, it will give you some idea what has to be done if it has a SBC in it!|||3 options





learn to drive stick





sell it to me





do the swap lol

No comments:

Post a Comment