My friend has a rebuilt performance chevy 350 and hes selling it cheap and i need to get my stang running. What would need to be done? What parts are compatible/incompatible?|||no!!! i have tryied it it did not fit plus if it did it would run crapy .
a ford mustang is to nice to do that
KEEP IT A FORD MUSTANG
CHEVYS SUCK!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!鈥?;)|||You can do it. Just cut off the ford motor mounting brackets. measure the motor. then weld chevy brackets to the ford frame. You will also have to change your drivetrain (chevy trans/driveshaft).
Report Abuse
|||tyler your a simple minded idiot... last time i checked the most popular engine for a model a was a chevy small block.... DONT HATE
Report Abuse
|||oh and btw i was at the track about 10 years back and there was a 65 mustang runnin low 10's i asked the guy how the hell did you get that ford to run 10's he said "easy, i put a chevy 350 in it"
TRUE STORY
Report Abuse
|||why would you want to do this?....can it be done?
Yes with a lot of the "F" word....
FABRICATION, get yourself a nice bowtie with a blown engine cheap and put it where it belongs...|||Why? Cause a 390-460 will fit and stay Ford wih a little bit of modification.. KEEP IT FORD unless your talkin' 1928-1954|||the 350 will fit but will have to fab up some motor mounts and change out the tranny with a Chevy trans Th350 or Th400 will have to change the drive shaft end that fits into the end of the transmission.with one from a Chevy.buy an msd ignition like an msd6a should work,might have too fab up some type of exhaust also..there are no parts from chevy that work on fords,unless you make them fit...
No comments:
Post a Comment